roymeo
At 12:14 PM 3/28/2005, Michael Nadel wrote:
I have a large text file in a text cast member, and I want the text to be printable and appear on multiple pages. I have a registered printomatic. What I did until now was I had to divide the text into a few text members. Otherwise printomatic simply shrinks the whole text onto one paper...
The problem with this way is 1) it's hard to divide up the text. 2) the text comes out different sizes, depending on the amount of text in each file / page. Is there an easier way?
Until now I've been using the following code:
set doc = new(xtra "PrintOMatic")
if not objectP(doc) then exit
append doc, castLib "manual", TRUE
if doJobSetup (doc) = TRUE then print doc
set doc = 0
Michael Nadel MediArt.Corp "Creativity is more powerful than knowledge" -- Albert Einstein *********************************************************************** Tel: (972-2) 5807-454 Email: [EMAIL PROTECTED] Web: http://www.intelligineering.com/mediart/home.htm
[To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/lingo-l.cgi To post messages to the list, email [email protected] (Problems, email [EMAIL PROTECTED]). Lingo-L is for learning and helping with programming Lingo. Thanks!]
----------- Roy Crisman Macromedia Director Programmer, Lingo Guru, Multimedia Producer 277 N. Goodman St. Rochester, NY 14607-1162 (585)473-3492 home (585)615-2873 cell http://www.brokenoffcarantenna.com/ roymeo(AT)brokenoffcarantenna.com
[To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/lingo-l.cgi To post messages to the list, email [email protected] (Problems, email [EMAIL PROTECTED]). Lingo-L is for learning and helping with programming Lingo. Thanks!]
