Hi, Thanks for all your answers guys, very helpful. I don't particularly dislike repeat loops, I was just wondering if there was a more efficient way.
I think I am going to investigate the pRegEx solution (re_copy) that I found in direct-l list that was suggested by Martin Pallett. And see if that helps, if there is very little discernable performance increase, it will at least significantly reduce code, as I will use it in several places, and luckily, I have already been making use of the pRegEx Xtra in my script. Thanks again Tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Alex da Franca Sent: 11 April 2005 23:12 To: Lingo programming discussion list Subject: Re: <lingo-l> joining lists in lingo Am 11.04.2005 um 23:42 schrieb Buzz Kettles: > > I was going to mention this aspect too, but figured the performance > difference was enough of a good enough reason. after all I don't quite understand, what is so bad about the little repeat loop. I for one like repeat loops... ;-) if only I could collapse them in the script editor at last... :-) --------------------------- ||| a�ex [To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/lingo-l.cgi To post messages to the list, email [email protected] (Problems, email [EMAIL PROTECTED]). Lingo-L is for learning and helping with programming Lingo. Thanks!] [To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/lingo-l.cgi To post messages to the list, email [email protected] (Problems, email [EMAIL PROTECTED]). Lingo-L is for learning and helping with programming Lingo. Thanks!]
