Make sure that you have the sprite actually selected in the score.
Say, for example you had previously selected sprite 10, which runs from
frame 6 to 20 and viewed the behaviors in the PI. If you keep the
behavior tab open in the PI and say your movie runs to frame 30, the
behavior tab is still set to the sprite (which ended in frame 20). So,
you click on it and there is no longer the sprite to look up information
for.
Kraig
| -----Original Message-----
| From: [EMAIL PROTECTED]
| [mailto:[EMAIL PROTECTED] On Behalf
| Of Mendelsohn, Michael
| Sent: Wednesday, May 25, 2005 4:50 PM
| To: Lingo programming discussion list
| Subject: <lingo-l> GPDL not holding values
|
| Hi list...
|
| I'm stumped - my getPropertyDescriptionList values
| aren't being held. I drop the behavior on the sprite,
| set my values in the GPDL, and then in the behavior
| panel, the values are gone. I've looked over the code
| again and again. What silly obvious thing am I overlooking?
|
| Thanks,
| - Michael M.
|
|
| [To remove yourself from this list, or to change to
| digest mode, go to http://www.penworks.com/lingo-l.cgi
| To post messages to the list, email [email protected]
| (Problems, email [EMAIL PROTECTED]). Lingo-L is
| for learning and helping with programming Lingo. Thanks!]
|
|
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/lingo-l.cgi To post messages to the list, email
[email protected] (Problems, email [EMAIL PROTECTED]). Lingo-L is for
learning and helping with programming Lingo. Thanks!]
