At 5:06 PM +0100 1/16/06, you wrote:
On 16-jan-2006, at 16:34, Rob Romanek wrote:
Actually you don't need to use the syntax of float(1.1) above. Just
use 1.1, any time you put a float into your operation the result
will be a float value. Try it in the message window.
Hey, you're right! I'm pretty sure this used to be different in
version ??? (i've used dir for more time than I care to remember)
Never noticed it had changed.
it's always been this way - I've never used float - I just multiply by 1.0
Mark Hagers
[EMAIL PROTECTED]
[To remove yourself from this list, or to change to digest mode, go
to http://www.penworks.com/lingo-l.cgi To post messages to the
list, email [email protected] (Problems, email
[EMAIL PROTECTED]). Lingo-L is for learning and helping with
programming Lingo. Thanks!]
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/lingo-l.cgi To post messages to the list, email
[email protected] (Problems, email [EMAIL PROTECTED]). Lingo-L is for
learning and helping with programming Lingo. Thanks!]
