Hi,
I have created many flash graphics for Director in the past but this
is a new one technical difficulty.
I have an animation that runs in Flash then stops (by design).
Nothing is moving. The flash file sits on the stage and there are
active buttons waiting for a user to click. If I just have the flash
animation sitting there and I am using a go to frame command, the fan
on the laptop kicks in and eventually gives a warning that the
computer is getting too hot. I have never seen this before. As far as
I can tell I have nothing looping in the Flash file to cause this
behavior.
Any suggestions?
Thanks,
Greg
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/lingo-l.cgi To post messages to the list, email
[email protected] (Problems, email [EMAIL PROTECTED]). Lingo-L is for
learning and helping with programming Lingo. Thanks!]
