hello again,
i nearly had a heart-attack when i opened my project this morning,
so i hope you can help me convalesce.
about three-quarters of my bitmaps are showing up as white areas,
when yesterday evening they were just fine and dandy!
*aaargh*
essentially, with each bitmap i'm using the same few lines of code to put it
on the stage.
all bitmaps are in castLib 1.
sprite(whichSprite).puppet= TRUE
sprite(whichSprite).member= member("memberName", 1)
member("memberName").regPoint= point(0, 0)
sprite(whichSprite).locH= value
sprite(whichSprite).locV= value
sprite(whichSprite).width= value
sprite(whichSprite).height= value
i've checked all properties that i could think of and that seemed to maybe
be relevant in the message window...
ink... blend...
it just makes no sense to me whatsoever.
heeeelp????
thank you,
heike .-(
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/lingo-l.cgi To post messages to the list, email
[EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]). Lingo-L is for
learning and helping with programming Lingo. Thanks!]
