fxObj = xtra("FileXtra4").new()
put fxObj.fx_FileRunApp(THE PATH TO YOUR APP)
alert fxObj.fx_ErrorString()
fxObj = 0Tony
tisdagen den 16 september 2003 kl 15.43 skrev Locke Morgan:
I have tried Buddy API but it seems to be a dead end for what I am trying to
do.
Essentially, I would like to be able to, from a projector, make a
non-Director App active, send a few commands and have the projector become
active again. (I wouldn't mind if the different programs did not switch
"activeness," just so long as I can send the commands to the outside App).
I am looking at updateStage's MasterApp, but would like to find something less expensive. (or even make Buddy API do the job)
Regards, W. Locke Morgan
[To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/lingo-l.cgi To post messages to the list, email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]). Lingo-L is for learning and helping with programming Lingo. Thanks!]
[To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/lingo-l.cgi To post messages to the list, email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]). Lingo-L is for learning and helping with programming Lingo. Thanks!]
