----- Original Message -----
From: pua jeand <[EMAIL PROTECTED]>
Subject: <lingo-l> sound loop
> how do i play sound from 1.dir to 2.dir, but the sound still continue
> playing, without start all over again..(Lingo pls)
> (i also hope when qt movie playing that time, the sound still playing).
You do not apply much information on what kind of sound it is (puppet/score, etc) or
what environment your movies are played on, but off the top of my head you might want
to try one of the following:
1) When 2.dir plays the sound (assuming it does and it's a puppetsound) you could make
it check first if the sound is already playing, and only start it if it isn't.
2) Put some or all of your soundplaying into a MIAW (assuming you're not running
shockwave) and tell the MIAW to play sounds whenever you want them played. That way
the sound will never get interrupted when you jump from movie to movie on your main
stage. This is a very useful technique, which I have used and benefitted from a lot.
hope this helps somewhat.
/jonas
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
