Thanks Roy
That solved it - I was using VPC (note: running from sharedfolder works
with softwin 98)
on 21/9/00 5:26 pm, John Aquilina at [EMAIL PROTECTED] wrote:
> Reply to: Re: <lingo-l> Projector problem
> This problem is due to the fact that your CD name is too long
>
> johnAq
>
>
>
> Roy Pardi wrote:
>> At 10:02 AM -0500 9/21/2000, Rob Madgwick wrote:
>>
>>> I have created my project on dir8 Mac - created a projector no problem -
>>> then opened up my project on dir8 Win and created a win projector, but on
>>> running it I get the error message:
>>>
>>> Unable to load movie playlist. Does the .INI file exist. It must contain a
>>> section "[Movies]" with an entry 'Movie01=Pathname.dir'
>>>
>>> though it runs fine from within dir8
>>>
>>> can anyone point me in the right direction
>>
>>
>> Don't know if this is a direction - but I have had the same issue >come up
>> when creating a projector for the PC on a Mac running VPC. >With the
>> projector in the Mac/PC shared folder, I would get this >error message.
>> Moving the projector to the C drive resolved it. I >thought this was a VPC
>> issue - but you might try moving it to your >primary drive (if it isn't there
>> already).
>>
>
>
>
>
> [To remove yourself from this list, or to change to digest mode, go to
> http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
> email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
> Lingo-L is for learning and helping with programming Lingo. Thanks!]
>
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
