Reply to: RE: <lingo-l> screen flash
ian hobbs wrote:
>when a new movie is called
>the screen flashes between movies
>only a millisecond or so but enough to be really annoying
>the movie backgrounds are black.
It's probably simple, chances are that there is a blank frame at the
beginning of your second movie
no
>this happens in full screen mode as well !
>any assistance?
In full screen mode, if your movie is smaller than the screen you will see
a border around the movie the same color as the movie background, so make
sure they are the same colour (sound like you have done this)
Also
� make sure that your movie/projector preferences are set to 'Match first
movie', so that the new movie will not jump to it's saved location.
worth looking at even with the current solution - see below.
� do to check on 'Reset monitor to movie's color depth'
johnAq
Thanks
so far I Think the solution is in anticipating
whats being required by the screen
I have inserted a preLoadMovie
command in the first line of the load movie buttons
(which have a small delay and click behaviour sequence)
this seems to have eliminated what appears to be
momentary loss of control of fullscreen colour etc
between movies within the projector
It has been a good problem !
cheers ian
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
