have director loop on a frame containing "movie 1" until
member("movie 1").movieTime=2000
where "movie 1" is the name of the cast member of the first movie and the
number (2000) is the length of the video. This is under the QuickTime
properties tab, but it is only displayed when you click the button to vew
the properties in list mode. I'm not sure what the units are.
Anyway, just loop on each frame until the movieTime reaches the end of the
movie then go to the next frame.
Charlie Fiskeaux II
The Creative Group
www.cre8tivegroup.com
859/858-9054 x29
cell: 859/312-3883
----- Original Message -----
From: "Ian Richardson" <[EMAIL PROTECTED]>
To: "director" <[EMAIL PROTECTED]>
Sent: Thursday, March 15, 2001 9:47 AM
Subject: <lingo-l> How do i ? : QT
I have a series of QT movies 10 in total, is it possible to have the
director move to the next movie after one is complete automatically. I have
figured the simple way is to do it manually but wondered if i can do it
automatically in sequence, and if so how?
TIA
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
