>I have tried many other ways but all have the same result:
>the cursor changes whenn first entering the stage (ie cross-hairs in
>this eg) but won't change back when leaving the stage area.
>
>Any ideas?
In a sense, it's impossible. Once the cursor is outside of the stage
area, cursor change commands don't work. The solution to the problem
is to have a slightly smaller than stage area that if the cursor
leaves you then set the cursor, which should take effect because
you're still over the stage.
--
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
