Hi

Is it possible to add a cast member to the stage, and assign it a sprite
name, at run-time using Lingo?

Thanks

Simon

________________________________________

Simon Wheatley
Senior Web Designer

Marlborough Stirling
Allen Jones House, Jessop Avenue
Cheltenham GL50 3SH

* 01242 547185 (Direct Line)
*     07971 687295 (Mobile)
* 01242 547122 (Fax)
*   [EMAIL PROTECTED]
________________________________________



______________________________________________________________

CONFIDENTIALITY NOTICE
This communication and the information it contains is intended for the person or 
organisation to whom it is addressed.  Its contents are confidential and may be 
protected in law.  Unauthorised use, copying or disclosure of any of it may be 
unlawful.  If you are not the intended recipient, please contact us immediately.

The contents of any attachments in this e-mail may contain software viruses, which 
could damage your own computer system.  While Marlborough Stirling has taken every 
reasonable precaution to minimise this risk, we cannot accept liability for any damage 
which you sustain as a result of software viruses.  You should carry out your own 
virus checking procedure before opening any attachment.

Marlborough Stirling plc, Registered No. 3008820,
Allen Jones House, Jessop Avenue, Cheltenham, Gloucestershire, GL50 3SH
Tel: 01242 547000     Fax: 01242 547100
http://www.marlborough-stirling.com

The following companies are subsidiaries of Marlborough Stirling plc and are 
registered in England and Wales at the above address:
Marlborough Stirling PLC, Registered No. 3008820
The Marlborough Stirling Group PLC, Registered No. 1855353
Marlborough Stirling Administration Limited, Registered No. 2341195
Metgem Limited, Registered No. 02341195

[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi  To post messages to the list,
email [EMAIL PROTECTED]  (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo.  Thanks!]

Reply via email to