>on startMovie > set the searchPaths = ["@\Files\", "@\FolderA\"] >end
Couldn't your projector be at the highest level you'll need? That way the start up movie (the first one in the projector) could set the searchpaths like this: mp = the moviepath id = the last char of mp set the searchpaths = [mp ,mp&"FolderA"&id, ,mp&"FolderB"&id, ,mp&"FolderC"&id] Colin and Roy, Thank you both for solving my problem, both your codes work so no fighting, boys! My projector is outside the folder called "Files", by the way. But I found that an additional piece of code is required as follows, and then Colin, your code works wonderfully: on mouseUp go to movie "@\\nameOfMovie.dir" end Thank you both again - you don't realise how I bashed my head against this wall, and it's really all so simple.... Regards, Venetia Daniolos --------------------------------------------- This message was sent using M-Web Airmail. http://airmail.mweb.co.za/ [To remove yourself from this list, or to change to digest mode, go to http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list, email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED]) Lingo-L is for learning and helping with programming Lingo. Thanks!]
