Well here is one way
the following code would go in a behavior, that would be attached to a
sprite
property pSprite --reference to sprite
property spriteNum
property pTimeout
on beginSprite me
psprite=sprite(spriteNum)
pTimeout=timeout("fade in").new(1,#fadeIn,me)
end beginSprite
on fadeIn me
if pSprite.blend>0 then
pSprite.blend=pSprite.blend-1
else
pTimeout.forget()
end if
end fadeIn
--
I don't know if it is faster, but to me it works far better.
----- Original Message -----
From: "Charlie Fiskeaux II" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, October 30, 2001 6:25 AM
Subject: Re: <lingo-l> re:frame rate question
> When you say animate with Lingo, could you give an example of a simple
opacity change transition in Lingo? Also, is animating it
> with Lingo necessarily faster than using the score? If so, why?
>
> Charlie Fiskeaux II
> The Creative Group
> www.cre8tivegroup.com
> 859/858-9054 x29
> cell: 859/312-3883
>
>
> ----- Original Message -----
> From: "brad condran" <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Tuesday, October 30, 2001 1:16 PM
> Subject: Re: <lingo-l> re:frame rate question
>
>
> I think I'm tired!
>
> Just kidding, why don't you use Lingo to animate instead? Just a
suggestion.
> ----- Original Message -----
> From: "stacey mulcahy" <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Tuesday, October 30, 2001 8:48 AM
> Subject: <lingo-l> re:frame rate question
>
>
> > hi everyone,
> >
> >
> > quick question - if I do something at a frame rate of 10 fps, am I
> somewhat
> > safe to assume that it will run at the same rate on most computers? I
know
> > when you use 30 fps + higher, then you get different results between
> comps.
> > My problem is that I have to tone down this animation and I want to make
> it
> > as many comps friendly as possible- so I am taking the frame rate down
to
> > 10- and then adjusting the animation to get the effect needed. There are
a
> > few v ery short opacity changes ( like 5 frames at the most) etc.
> > What do you think?
> > thanks for the advice in advance
> > s
> >
> >
> > [To remove yourself from this list, or to change to digest mode, go to
> > http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
> > email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
> > Lingo-L is for learning and helping with programming Lingo. Thanks!]
> >
>
>
> [To remove yourself from this list, or to change to digest mode, go to
> http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
> email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
> Lingo-L is for learning and helping with programming Lingo. Thanks!]
>
>
> [To remove yourself from this list, or to change to digest mode, go to
> http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
> email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
> Lingo-L is for learning and helping with programming Lingo. Thanks!]
>
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]
