We might have to re-think that old joke about how many it takes to
change a light bulb....
I think there is something similar for my Light Sensor on my automatic
lighting or it might have been the generation before on a timer...
M
On 17/7/19 12:27 pm, Scott Howard wrote:
Installing a light build can be done by (most) anyone, without any special
skills, licenses, or tools, and at zero cost (other than the light bulb
itself, obviously)
Any other option requires a licensed electrician, and comes at a
significantly higher cost..
The "temporary" installation also has benefits as technology changes and
matures. Anyone that installed previous generation hard-wired controllers
(eg, z-wave) may currently be in a position of running devices which known
security issues, and no easy way to replace them.
Scott
On Tue, Jul 16, 2019 at 7:10 PM Roger Clarke <[email protected]>
wrote:
The thing my inadequate imagination isn't coming up with is why I would
want active silicon inside my light-bulb assembly.
Remote operation of lights can be achieved by installing active silicon
in a control panel that operates a bank of switches.
____________
On Wed, 2019-07-17 at 10:21 +1000, Roger Clarke wrote:
If you need to reset the software in your GE smart light bulb --
firmware version 2.8 or later -- just follow these easy instructions
On 17/7/19 11:24 am, Karl Auer wrote:
This procedure saves them the cost of a reset switch in the bulb
circuitry. A switch that they cannot have people operating in the
presence of 240V mains power, so would have to be on the base of the
bulb, inaccessible when the bulb is in place.
With the switch, the procedure would be "turn off light, remove bulb,
set switch, insert bulb, turn on light, bulb will flash three times,
turn off light, remove bulb, set switch off, insert bulb".
However, this procedure does not ensure that the customer turns off the
light before removing or inserting the bulb, so dramatically increases
the risk that the customer will electrocute themselves while trying to
reset the bulb. As bulb resets are not a function of ordinary light
bulbs, these electrocutions will immediately become "GE's fault", and
they don't want that.
The actual procedure directly incorporates having the bulb in place and
safe. The many steps ensure that the bulb is highly unlikely to reset
accidentally.
So not as insane as it may first appear...
Regards, K.
--
Roger Clarke mailto:[email protected]
T: +61 2 6288 6916 http://www.xamax.com.au http://www.rogerclarke.com
Xamax Consultancy Pty Ltd 78 Sidaway St, Chapman ACT 2611 AUSTRALIA
Visiting Professor in the Faculty of Law University of N.S.W.
Visiting Professor in Computer Science Australian National University
_______________________________________________
Link mailing list
[email protected]
http://mailman.anu.edu.au/mailman/listinfo/link
_______________________________________________
Link mailing list
[email protected]
http://mailman.anu.edu.au/mailman/listinfo/link
--
Marghanita da Cruz
Telephone: 0414-869202
Email: [email protected]
Website: http://ramin.com.au
_______________________________________________
Link mailing list
[email protected]
http://mailman.anu.edu.au/mailman/listinfo/link
