OK, I am making progress. I have learned how to use the F1 key and
mouse to gain help items that can be read on screen for the various
control boxes.
Now, I have Linrad running in CW mode (mode B), and am able to
process audio from the radio through Linrad. However, I have not
figured out how to do the same with the weak signal mode (A). When I
run mode A, I do not see anything on the waterfall display at all.
Then, for some unknown reason, I will see very bright lines appearing
as if something is being overdriven., but no signal line, even though
the radio is putting a carrier tone to Linrad. Is this an audio card
problem? It works fine in mode B, with expected waterfall display.,
but not so in mode A.
As usual, all help is appreciated.
Dave, W5UN
#############################################################
This message is sent to you because you are subscribed to
the mailing list <linrad@antennspecialisten.se>.
To unsubscribe, E-mail to: <[EMAIL PROTECTED]>
To switch to the DIGEST mode, E-mail to <[EMAIL PROTECTED]>
To switch to the INDEX mode, E-mail to <[EMAIL PROTECTED]>
Send administrative queries to <[EMAIL PROTECTED]>
