Jammie, You should be able to logon to the console as root, cd to /etc, then do echo needed.parm1 >> zipl.conf echo needed.parm2 >> zipl.conf echo needed.parm1 > /proc/chandev echo needed.parm2 > /proc/chandev echo read_conf > /proc/chandev ifup eth0 then cd /boot and re-run zipl to make the changes permanent.
Mark Post -----Original Message----- From: Hall, Jammie [mailto:[EMAIL PROTECTED]] Sent: Tuesday, February 19, 2002 10:12 AM To: [EMAIL PROTECTED] Subject: rh 7.2 zipl.conf okay, I made a mistake somewhere. I ran loader and install went well. however, when I ipl from dasd, I do not get my eth0. I run ifconfig and all it show is lo 127.0.0.1. I looked back and I did not put the chandev=lcs0 ... in the z/IPL boot loader. can I execute something to get my system up and then vi zipl.conf and add the needed parm or do I just have to start the loader process over. regards, j-me
