Was the device reported as being detected during the boot process? E.g., Detected device 010F on subchannel 0016 - PIM = F0, PAM = F0, POM = FF Detected device 0D0C on subchannel 0017 - PIM = F0, PAM = F0, POM = FF
Mark Post -----Original Message----- From: Liang, Ih-Cheng [mailto:[EMAIL PROTECTED]] Sent: Wednesday, April 24, 2002 11:57 AM To: [EMAIL PROTECTED] Subject: Re: try to load Gigabit OSA Ethernet driver qeth Yes, I loaded qdio first with insmod qdio. IC Liang. -----Original Message----- From: Post, Mark K [mailto:[EMAIL PROTECTED]] Sent: Tuesday, April 23, 2002 8:49 PM To: [EMAIL PROTECTED] Subject: Re: try to load Gigabit OSA Ethernet driver qeth Did you load the qdio module first? Mark Post -----Original Message----- From: Liang, Ih-Cheng [mailto:[EMAIL PROTECTED]] Sent: Tuesday, April 23, 2002 6:12 PM To: [EMAIL PROTECTED] Subject: try to load Gigabit OSA Ethernet driver qeth I have SuSE v7 running on an S390 LPAR. I tried to load Gigabit OSA Ethernet driver with the following command: insmod qeth qeth_options=noauto,0x0f0a,0x0f0b,0x0f0c This command failed with the following messages: Using /lib/modules/2.2.16/net/qeth.o /lib/modules/2.2.16/net/qeth.o: init_module: Device or resource busy Hint: this error can be caused by incorrect module parameters, including invalid IO or IRQ parameters Any suggestions what I did wrong? Thanks. IC Liang.
