Hi...
It appears that your adapters (NIC) are defined properly and coupled to the
LAN that you want. I would suggest, however, that you ask the owner of
your
CP system to install the following service to z/VM 4.2.0 :
CP APAR VM62938 PTF UM30225 which includes HiperSockets enablement
We were developing the CP simulation code at the same time the
hardware group was developing the HiperSockets millicode. Our
final adjustments were too late to make the GA tape.
CP APAR VM62958 PTF UM30140 which includes the fix for (probably) this same
problem
Device indexing was one of the last-minute changes and the device
index passed
to the driver via the CCW interface was incorrect in most cases.
When this service has been applied, you should be able to issue CP QUERY
VMLAN
and see "VM62938" listed as the latest service.
Also, Malcolm is correct in pointing out that "addparms" should be
"add_parms"
(I should remember this by now). That could also cause an initialization
failure.
Regards,
Dennis Musselwhite ([EMAIL PROTECTED])
IBM Corporation -- z/VM Development -- CP Network Simulation
