Should be 'add_parms'
WBR, Sergey
| "Seifert, Harald" <[EMAIL PROTECTED]>
Sent by: Linux on 390 Port <[EMAIL PROTECTED]> 17.12.2002 13:44
|
To: [EMAIL PROTECTED] cc: Subject: HOW define another OSA Interface ? |
I have zSLES7 running on in a LPAR of a zSeries 900, Kernel 2.4.17.
I'm using OSA GbE and have one Interface
up and running defined like this one
/etc/chandev
noauto;qeth0,0x0010,0x0011,0x0012;addparms,0x10,portname:OSAEG06
As SuSE states other definitions can be added like this one: noauto;qeth1,0x0020,0x0021,0x0022;addparms,0x10,portname:OSAEG07
noauto;qeth2,0x0030,0x0031,0x0032;addparms,0x10,portname:OSAEG08
noauto;qeth3,0x0040,0x0041,0x0042;addparms,0x10,portname:OSAEG09 .
Then I have issued an rcchandev reload and this worked.
A cat /proc/chandev shows that everything is fine.
Now I have used YAST to define the eth1,eth2,eth3 IP-Interfaces.
I did an actviavtion inside YAST.
SuSEConfig was running;
but ifconfig shows eth1-et3 not active.
Now I tried a rcnetwork restart command and
Linux didnot bring the network up again.
Only HMC console was available after that.
So my problem is,
how to activate the interfaces correctly.
Or did I miss something ?
Or should I try ifconfig.
Regards
Harald Seifert
Informatik-Systemprogrammierung
HUK Coburg
Bahnhofsplatz
96444 Coburg
Phone +049 (0)9561-961787
Fax +049 (0)9561-963671
Mailto [EMAIL PROTECTED]
Seifert, Harald.vcf
Description: Binary data
STG62835
Description: Binary data
