>I just tried that, (and another 100 variations) and after I select the >mount points (swap and / ) and it says it sees 2.2G of dasd, when I enter >'next' and it tries the installation again, I still get the same msg about >no proposal and not enough room for an install. ARGHHHH!!!! I've tried >formatting outside by hand, marking them for format by the install >process... no difference.
I also get the "No Proposal", but what I did was to Select Change and use the partitioner to assign the mount points. My problem now is that the load finished, but when I reboot, apparently the zipl.conf is not set up properly and it will not mount the file systems. Making almost no headway on this one. I agree with you about them fouling up the install process. The old way worked very well. They tried to make the new process prettier with X and VNC, but all they really managed to do was make it more difficult. Mark D Pace Senior Systems Engineer Mainline Information Systems 1700 Summit Lake Drive Tallahassee, FL. 32317 [EMAIL PROTECTED] Office: 850.219.5184 Fax: 850.219.5050 http://www.mainline.com
