Lpar 1 uses devices 830 and 831 and port 0 of an ENTR card. LPAR 2 is using devices 832 and 833 and port 1.
I have been able to see where to change all the other TCP/IP configuration stuff except the device numbers and port number. LPAR 2 should ideally be moved to LPAR 1 (or they have to re-configure the switch I'm in, OR I move the cables on the ENTR... Hmm... there's a thought). What do I use to change the hardware address information for the ENTR card so it will configure onto port 0? LPAR 1 is on disk that is leaving the building in about a week, and was a Suse 7.0 kdistro . I built lpar 2 under Suse 7.2 with CDL etc, but obviously couldn't use the same TCP/IP info without taking down the quasi prod lpar. Any ideas?
