I've been trying to get my network connected to my LINUX Lpar through a CTC connection. I think I have everything defined correctly. I did the IOCDS change last week, and put a couple of definitions in my MVS TCPIP Profile. I hooked up an Escon cable between 2 chpids. When I IPL Linux, I get the following error messages:
ctc0: unknown interface; No such device SIOCSIFDSTADDR: No such device ctc0: unknown interface; No such device I put most of the answers to the networking questions in my PARM.LINE file. I still get one question that asks: Please enter the parameters you need to pass to the channel device layer: and then has an example. I reply: "ctc0,0D00,0D01" What is going wrong? I've tried several different combinations, and always get the 3 messages above. I can send the things I've changed if that is necessary. I'll be out in the computer room and away from my PC trying this again. I will check for replies before I go home. I have to be somewhere, so I can't stay very late. I'll be here till 4:45 Central time. Otherwise, I'll reply in the morning. Thanks in advance. Eric Bielefeld Sr. MVS Systems Programmer P&H Mining Equipment Milwaukee, WI 414-671-7849 [EMAIL PROTECTED] +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ This electronic mail transmission contains information from P & H Mining Equipment which is confidential, and is intended only for the use of the proper addressee. If you are not the intended recipient, please notify us immediately at the return address on this transmission, or by telephone at (414) 671-4400, and delete this message and any attachments from your system. Unauthorized use, copying, disclosing, distributing, or taking any action in reliance on the contents of this transmission is strictly prohibited and may be unlawful. +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
