We are attempting have LINUX/390 use an EMC SAN. scsiload puts out a message about an 'unknown partition table' Are other folks using EMC SYMMETRIC successfully? Is there doc anywhere on how to configure the EMC SAN for LINUX/390?
Sep 16 09:05:24 linuxl1 kernel: scsi : 0 hosts left. Sep 16 09:05:24 linuxl1 kernel: zfcp: zfcp_module_init: driver version 0x3003c Sep 16 09:05:24 linuxl1 kernel: debug: zfcp_lock: new level 4 Sep 16 09:05:24 linuxl1 kernel: debug: zfcp_req0x4800: new level 1 Sep 16 09:05:24 linuxl1 kernel: debug: zfcp_cmd0x4800: new level 3 Sep 16 09:05:24 linuxl1 kernel: debug: zfcp_abt0x4800: new level 6 Sep 16 09:05:24 linuxl1 kernel: debug: zfcp_els0x4800: new level 6 Sep 16 09:05:24 linuxl1 kernel: debug: zfcp_erp0x4800: new level 3 Sep 16 09:05:24 linuxl1 kernel: scsi: limiting sg entries to 256 Sep 16 09:05:24 linuxl1 kernel: scsi0 : zfcp Sep 16 09:05:24 linuxl1 kernel: Vendor: EMC Model: SYMMETRIX Rev : 5567 Sep 16 09:05:24 linuxl1 kernel: Type: Direct-Access ANS I SCSI revision: 03 Sep 16 09:05:24 linuxl1 kernel: Vendor: EMC Model: SYMMETRIX Rev : 5567 Sep 16 09:05:24 linuxl1 kernel: Type: Direct-Access ANS I SCSI revision: 03 Sep 16 09:05:24 linuxl1 kernel: sd: find_free_slot ...<7>sd: ... found 08:00 Sep 16 09:05:24 linuxl1 kernel: Attached scsi disk sda at scsi0, channel 0, id 1 , lun 0 Sep 16 09:05:24 linuxl1 kernel: sd: find_free_slot ...<7>sd: ... found 08:10 Sep 16 09:05:24 linuxl1 kernel: Attached scsi disk sdb at scsi0, channel 0, id 1 , lun 1 Sep 16 09:05:24 linuxl1 kernel: SCSI device sda: 15360 512-byte hdwr sectors (8 MB) Sep 16 09:05:24 linuxl1 kernel: sda:<4>dasd: No device registered as device (8: 0) Sep 16 09:05:24 linuxl1 kernel: unknown partition table Sep 16 09:05:24 linuxl1 kernel: SCSI device sdb: 15360 512-byte hdwr sectors (8 MB) Sep 16 09:05:24 linuxl1 kernel: sdb:<4>dasd: No device registered as device (8: 16) Sep 16 09:05:24 linuxl1 kernel: unknown partition table
