Ila, I looked through several versions of the "Device Drivers and Installation Commands" manuals, and the only NIC driver that had any provision for specifying a port number was for LCS. If you're using it in LCS mode, then look in /etc/chandev.conf. If you're using it in QDIO mode, then you should not have to change anything.
Mark Post -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] Behalf Of Miller, Ila Sent: Thursday, December 18, 2003 9:22 AM To: [EMAIL PROTECTED] Subject: New z900 and SuSE Linux partitions We are getting a new z900 and would like the three linux partitions running on the X47 partitions to come up and run there. One of the SuSe Linux partitions is running on an OSA Express Card port 1. The card cannot be moved to the new machine. Is there a way to change the SuSe Linux to use port 0 by updating some config file? I believe on the new machine, the address of the OSA card can be set the same as the address on the X47 and if SuSe was set to use port 0 it should work without a regen/rebuild of Linux and all that is running. When I installed SuSe Linux on the Network setup I set the Network device address: to the correct address, and then Relative port was set to 1, because at the time something else was using port 0. So I am hoping this is in a file somewere and can be changed and port 0 will be used without problems. Can anyone give me advice? Ila Z. Miller ___________________________________________________________ ___________________________________________________________ Health Care Information Systems University of Iowa Hospitals & Clinics [EMAIL PROTECTED] Phone: 319.356.0067 FAX: 319.356.3521 Notice: This e-mail (including attachments) is covered by the Electronic Communications Privacy Act, 18 U.S.C. 2510-2521, is confidential and may be legally privileged. If you are not the intended recipient, you are hereby notified that any retention, dissemination, distribution, or copying of this communication is strictly prohibited. Please reply to the sender that you have received the message in error, then delete it. Thank you.
