Sorry, I missed the "then run..." Thanks, Lee
At 04:02 PM 5/24/2004, you wrote:
No, you didn't forget, and I did answer. It's the second paragraph you included below.
Mark Post
-----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Lee Stewart Sent: Monday, May 24, 2004 5:58 PM To: [EMAIL PROTECTED] Subject: Re: Moving boot volume
I forgot to ask... How does one write the IPL text on the new volume? Lee
At 03:32 PM 5/24/2004, you wrote: >For moving the data, http://linuxvm.org/Info/HOWTOs/movefs.html > >Once the swap partition has been created, you'll need to run the >"mkswap" command against it. This will only need to be done one time. > >Writing the IPL text onto the new volume would be done after the data >has been copied over. Then, chroot to the mount point, update >/etc/zipl.conf with the correct DASD device number, create a new initrd >if needed, and run the zipl command. > >If you have an OSA connection, or CTC, etc., you'll need to update >/etc/chandev.conf with the new information. > > >Mark Post
Lee Stewart, Senior SE DSG (719) 566-0188 , Fax (719) 566-0655 [EMAIL PROTECTED] www.dsgroup.com
---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
Lee Stewart, Senior SE DSG (719) 566-0188 , Fax (719) 566-0655 [EMAIL PROTECTED] www.dsgroup.com
---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
