When the interface initializes using normal tools (without the echo command), what shows up in dmesg?
Mark Post -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Mrohs, Ray Sent: Wednesday, September 08, 2004 9:05 AM To: [EMAIL PROTECTED] Subject: Primary router question We are setting up a couple Linux SLES8 routers to connect hipersockets test and production networks with separate OSA ports. One of them works as expected. The other does not come up as a router, its /proc/qeth is as follows: devnos (hex) CHPID device cardtype port chksum prio-q'ing rtr fsz C cnt -------------- --- ---------- -------------- -- -- ---------- --- --- - --- 0600/0601/0602 xFC hsi1 HiperSockets 0 no always_q_2 no 24k 128 0E40/0E41/0E42 x00 eth0 OSD_1000 0 no always_q_2 no 64k 128 Here is the entry for the router interface in chandev.conf: noauto;qeth0,0x0e40,0x0e41,0x0e42;add_parms,0x10,0x0e40,0x0e42,portname:DEV0 E00,p rimary_router Running 'rcchandev reload' doesn't have any effect. The only thing that works so far is a manual "echo primary_router eth0 > /proc/qeth". Once this is done, it works fine. I suppose we could 'dumbly' add this command at startup, but it seems theres an underlying problem. Ray Mrohs Energy Information Administration U.S. Department of Energy ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
