Isn't there way to use the SE or HMC to manipulate the OSA/2's OAT? We have a z800 and OSA-Express and the documentation on that box shows how to control the OSA-Express totally from the HMC. I don't know if this is possible with an MP3K or not. I have a lot of manuals (pdf format) on the MP3K, but nothing in them talks about the OSA/2.
-- John McKown Senior Systems Programmer UICI Insurance Center Information Technology This message (including any attachments) contains confidential information intended for a specific individual and purpose, and its' content is protected by law. If you are not the intended recipient, you should delete this message and are hereby notified that any disclosure, copying, or distribution of this transmission, or taking any action based on it, is strictly prohibited. > -----Original Message----- > From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On > Behalf Of Ward, Garry > Sent: Wednesday, September 08, 2004 2:20 PM > To: [EMAIL PROTECTED] > Subject: Re: [Possible Spam] Re: [Possible Spam] Have a > serious problem with mp2003 > > > As far as I know, you need either VSE, VM or MVS on the > system to tinker > with the OAT. We always had VSE in one of the LPARs. > > You don't need much of a VSE system, you can probably get > with with just > a BASIC startup. > > -----Original Message----- > From: Linux on 390 Port [mailto:[EMAIL PROTECTED] Behalf Of > Noll, Ralph > Sent: Wednesday, September 08, 2004 3:15 PM > To: [EMAIL PROTECTED] > Subject: [Possible Spam] Re: [Possible Spam] Have a serious > problem with > mp2003 > > > Yes osa/osa2 card... > > How do I load the oat .. I've done it via vse.. But how > Do I do that on a plain jane system with no interface.. > > Ralph > > > -----Original Message----- > > From: Ward, Garry [mailto:[EMAIL PROTECTED] > > Sent: Wednesday, September 08, 2004 2:10 PM > > To: [EMAIL PROTECTED] > > Subject: Re: [Possible Spam] Have a serious problem with mp2003 > > > > Umm, are you using an OSA/OSA2 card? > > > > Has the OAT been redefined and reloaded? > > > > -----Original Message----- > > From: Linux on 390 Port [mailto:[EMAIL PROTECTED] > > Behalf Of Noll, Ralph > > Sent: Wednesday, September 08, 2004 3:01 PM > > To: [EMAIL PROTECTED] > > Subject: [Possible Spam] Have a serious problem with mp2003 > > > > > > > > Ipl'ing Debian from tape on the mp2003 > > > > When I setup the ip address other than 10.37.1.21 It will > > not work.. Can't ping the gateway of 10.37.1.1 > > > > > > > > I setup the ip to 10.37.1.21 works fine > > > > Any idea of where in the mp2003 that the problem could be.. > > Been working for 2 days on this... > > Anyone else run into this.. Or have you all junked your Mp2003... > > > > > > Thanks > > > > Ralph > > > > > ---------------------------------------------------------------------- > > For LINUX-390 subscribe / signoff / archive access > > instructions, send email to [EMAIL PROTECTED] with the > > message: INFO LINUX-390 or visit > > http://www.marist.edu/htbin/wlvindex?LINUX-390 > > > > > > Confidentiality Warning: This e-mail contains information > > intended only for the use of the individual or entity named > > above. If the reader of this e-mail is not the intended > > recipient or the employee or agent responsible for delivering > > it to the intended recipient, any dissemination, publication > > or copying of this e-mail is strictly prohibited. The sender > > does not accept any responsibility for any loss, disruption > > or damage to your data or computer system that may occur > > while using data contained in, or transmitted with, this > > e-mail. If you have received this e-mail in error, please > > immediately notify us by return e-mail. Thank you. > > > > > ---------------------------------------------------------------------- > > For LINUX-390 subscribe / signoff / archive access > > instructions, send email to [EMAIL PROTECTED] with the > > message: INFO LINUX-390 or visit > > http://www.marist.edu/htbin/wlvindex?LINUX-390 > > > > ---------------------------------------------------------------------- > For LINUX-390 subscribe / signoff / archive access instructions, > send email to [EMAIL PROTECTED] with the message: INFO > LINUX-390 or > visit > http://www.marist.edu/htbin/wlvindex?LINUX-390 > > ---------------------------------------------------------------------- > For LINUX-390 subscribe / signoff / archive access instructions, > send email to [EMAIL PROTECTED] with the message: INFO > LINUX-390 or visit > http://www.marist.edu/htbin/wlvindex?LINUX-390 > ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
