Rob van der Heij <[EMAIL PROTECTED]> wrote:
>The parmfile is generated by zipl, so any changes to the kernel
>command line must be in the /etc/zipl.conf and then run zipl before
>reboot.
That depends (*). If you use the tag "parmfile=" in your zipl.conf, zipl
will just read that parameter line. On the
other hand you can use "parameters=" to specify the parameters in
zipl.conf and the tool will create a parmfile
with the content for you.
(*) this sentence was shamelessly stolen from Bill Bitner
with kind regards
Carsten Otte
--
omnis enim res, quae dando non deficit, dum habetur et non datur, nondum
habetur, quomodo habenda est
Rob van der Heij <[EMAIL PROTECTED]>
Sent by: Linux on 390 Port <[EMAIL PROTECTED]>
28/09/2004 08:06 PM
Please respond to Rob van der Heij
To: [EMAIL PROTECTED]
cc:
Subject: Re: VM Shutdown
On Tue, 28 Sep 2004 08:05:21 -0600, Seader, Cameron
<[EMAIL PROTECTED]> wrote:
> Do you add this to the file /boot/zipl/parmfile and the run the zipl
command and reboot.
The parmfile is generated by zipl, so any changes to the kernel
command line must be in the /etc/zipl.conf and then run zipl before
reboot.
--
Rob van der Heij rvdheij @ gmail.com
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
