Is there another way besides using the yast interface? -----Original Message----- From: Ranga Nathan [mailto:[EMAIL PROTECTED] Sent: Wednesday, December 29, 2004 2:24 PM To: [email protected] Subject: Re: Question re: Linux SLES9
If the dasd address was genned for the LPAR, then it should be visible in "yast" under system (or hardware) --> DASD. You can then activate it, format and mount. __________________________________________ Ranga Nathan / CSG Systems Programmer - Specialist; Technical Services; BAX Global Inc. Irvine-California Tel: 714-442-7591 Fax: 714-442-2840 [EMAIL PROTECTED] Sent by: Linux on 390 Port <[email protected]> 12/29/2004 02:09 PM Please respond to Linux on 390 Port To: [email protected] cc: Subject: Question re: Linux SLES9 SLES9 for S/390 (64-bit) in an LPAR > (no VM) using a shared IFL (I have one other LPAR running SLES9 31-bit) I have looked and I have not seen any documentation that shows how to add a dasd unit via command line under SLES9. Under SLES8 I used to execute echo "add device range=xxxx" >> /proc/dasd/devices And then I would execute the following to view the changes: cat /proc/dasd/devices But that does not seem to work any more. ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
