Can some tell me the differences between adding dasd to sles 9 from sles 8.
On sles 8 I would attach the dasd echo "add device range=xxx-xxx " >> /proc/dasd/devices cat /proc/dasd/devices would show the new devices. Then I would update zipl.conf to add the address range and run zipl. On sles 9 I attached the dasd, echo "add device range=xxx-xxx " >> /proc/dasd/devices But when I look at /proc/dasd/devices I do not see the newly attached devices. Also in zipl.conf I do not see a parameter for the dasd address range. Thanks for any comments. Mark D Pace Senior Systems Engineer Mainline Information Systems 1700 Summit Lake Drive Tallahassee, FL. 32317 Office: 850.219.5184 Fax: 888.221.9862 http://www.mainline.com This e-mail and files transmitted with it are confidential, and are intended solely for the use of the individual or entity to whom this e-mail is addressed. If you are not the intended recipient, or the employee or agent responsible to deliver it to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you are not one of the named recipient(s) or otherwise have reason to believe that you received this message in error, please immediately notify sender by e-mail, and destroy the original message. Thank You. ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
