700-702 are virtual devices defined as a NIC attached to a VSWITCH and defined as follows. NICDEF 700 TYPE QDIO LAN SYSTEM ZSWPROD1
I found the problem - I forgot to grant access to the guest for the vswitch. It is now working O.K. Thanks for the help. David Kreuter <[EMAIL PROTECTED]> Sent by: Linux on 390 Port <[email protected]> 04/20/2005 12:01 PM Please respond to Linux on 390 Port <[email protected]> To [email protected] cc Subject Re: qeth initialization failure trying to install SLES9 What are the devices at 700-702? To use a vswitch the OSA-Express is not attached to a virtual machine - TCPIP controller will manage. 700-702 should be virtual NICs coupled to the guest lan. David ________________________________ From: Linux on 390 Port on behalf of Tom Driscoll Sent: Wed 4/20/2005 12:35 PM To: [email protected] Subject: qeth initialization failure trying to install SLES9 I am trying to install SLES9 (31 bit) under z/VM 5.1 and am getting the error below. Address 700-702 points to a VSWITCH. Has anyone seen this before? Are these codes documented anywhere? Thanks. Messages: Loading qeth... qdio: loading QDIO base support version 2 ($Revision: 1.79.2.1 $/$Revision: 1.57 $/$Revision: 1.23 $) qeth: loading qeth S/390 OSA-Express driver ($Revision: 1.77.2.20 $/$Revision: 1 .98.2.11 $/$Revision: 1.27.2.5 $/$Revision: 1.8.2.2 $/$Revision: 1.7.2.1 $/$Revi sion: 1.5.2.4 $/$Revision: 1.19.2.7 $ :IPv6 :VLAN) Detecting available channels ... done 3 OSA Express, Gigabit Ethernet or High Speed Token Ring Channels were detected. First OSA Express, Gigabit Ethernet or High Speed Token Ring Channels that were detected: Device Addresses CHPID(s) 0700 01 0701 01 0702 01 Format for OSA Express configuration: Read Channel,Write Channel,Data Channel The Read Channel must be an even device address, The Write Channel must be the Read Channel address plus 1, The Data Channel must be the Read Channel address plus 2. Possible configuration: read: 0x0700, write: 0x0701, data: 0x0702 Enter the device addresses for the qeth module, e.g. '0.0.0700,0.0.0701,0.0.0702 ' Device 0.0.0700 configured qeth: received an IDX TERMINATE with cause code 0x4e qeth: Initialization in hardsetup failed! rc=-5 eth0: error fetching interface information: Device not found eth0 not available, check device addresses/cards. Do you want to retry the qeth-setup (Yes/No) ? ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
