Did you do Parmfile as bin or ascii?
"Froberg, David C" <[EMAIL PROTECTED]> Sent by: Linux on 390 Port <[email protected]> 05/24/2005 09:56 AM Please respond to Linux on 390 Port To: [email protected] cc: Subject: Re: [LINUX-390] SLES9 Install with FTP under VM question > > When you transfer the files to VM make sure the files are > being transferred Fixed 80 with the VMRDR and INITRD files in > binary. Chapter 8.3 of the SUSE sles9 manual > "Architecture-Specific Information". This manual is on the > sles9 CD1 disk. > Thanks for all your replies so far. I should have just included the rest of the ftp log. I did set Fixed 80 and Bin. Note the byte count of the 150 Opening message is different from the byte count after the tranfer is done: Command: locsite fix 80 Command: bin >>>TYPE i Command: >>>CWD /sles/sles9/sles9/CD1/boot 250 Directory successfully changed. Command: get vmrdr.ikr sles9.image (rep >>>PORT 200 PORT command successful. Consider using PASV. >>>RETR vmrdr.ikr 150 Opening BINARY mode data connection for vmrdr.ikr (4556148 bytes). 226 File send OK. 4556160 bytes transferred in 1.149 seconds. Transfer rate 3965.33 Kbytes/sec. Command: get initrd sles9.initrd (rep >>>PORT 200 PORT command successful. Consider using PASV. >>>RETR initrd 150 Opening BINARY mode data connection for initrd (12361298 bytes). 226 File send OK. 12361360 bytes transferred in 3.167 seconds. Transfer rate 3903.18 Kbytes/sec. Command: ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
