The nic interfaces seem to be setup correctly.
ie) linux-00:~ # qethconf vipa list
vipa add 10.115.20.185 eth0
vipa add 10.115.20.185 eth1
here is the hcp q nic details (editted)
Unicast IP Addresses:
10.115.20.185 ( this is the vipa addr)
10.115.136.51 (eth0)
Unicast IP Addresses:
10.115.20.185
10.115.137.51 (eth1)
Jim Barnett
United Health Technologies
Mainframe Systems
763-744-3066
email: [EMAIL PROTECTED]
Ronald van der Laan <[EMAIL PROTECTED]>
Sent by: Linux on 390 Port <[email protected]>
08/11/2006 12:54 AM
Please respond to
Linux on 390 Port <[email protected]>
To
[email protected]
cc
Subject
Re: zLinux VIPA setup.
Jim,
Your vipa should be registered to your NIC to be able to receive packets
(unless you set up a layer 2 vswitch), you can check that using:
$ hcp q nic xxxx details (xxxx being the address of your eth0 or eth1
virtual NIC)
If it does not show your vipa, you can set it manually using:
$ qethconf vipa add xxx.xxx.xxx.xxx eth0
$ qethconf vipa add xxx.xxx.xxx.xxx eth1
Ronald van der Laan
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
This e-mail, including attachments, may include confidential and/or
proprietary information, and may be used only by the person or entity to
which it is addressed. If the reader of this e-mail is not the intended
recipient or his or her authorized agent, the reader is hereby notified
that any dissemination, distribution or copying of this e-mail is
prohibited. If you have received this e-mail in error, please notify the
sender by replying to this message and delete this e-mail immediately.
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
