Arty, Might be helpful to look at Novell's multipath-tools how-to steps at http://support.novell.com/techcenter/sdb/en/2005/04/sles_multipathing.ht ml
and this multipath-tools doc http://www.novell.com/documentation/sles10/index.html?page=/documentatio n/sles10/stor_evms/data/b4qbr1x.html -------------------------------------------------------- This e-mail, including any attachments, may be confidential, privileged or otherwise legally protected. It is intended only for the addressee. If you received this e-mail in error or from someone who was not authorized to send it to you, do not disseminate, copy or otherwise use this e-mail or its attachments. Please notify the sender immediately by reply e-mail and delete the e-mail from your system. -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Volker Sameske Sent: Friday, October 20, 2006 4:24 AM To: [email protected] Subject: Re: Installing SLES9 to multipathed FCP SCSI Hi Arty, > I normally use evms for FCP SCSI path multipathing, > but I can't figure out how to get evms to add the requisite regions during > the install process. I'd hate to have to pre-build the evms segments prior > to the install process. Have you ever considered to use multipath-tools and LVM2 instead of EVMS? We have done much more tests with mp-tools compared to EVMS. Please have a look at: http://download.boulder.ibm.com/ibmdl/pub/software/dw/linux390/docu/l26c ts00.pdf chapter 5. regards, Volker ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
