I got farther this time. I completed the installation and IPLed from my DASD volume. It started to come up, but froze and went into a disabled wait after trying to start gmp.
Starting gmp: /usr/sbin/gmp -m /dev/mouse -t ps2 gmp: oops() invoked from gmp.c(955) Failed on virtual console check: No such file or directory Bash-3.00# I don't need any mouse support for Slack/390, but the setup seemed to force me to choose a mouse driver. Do I need to reinstall and exclude the mouse package(s)? Is there any way to fix it without reinstalling everything? Russ -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Mark Post Sent: Thursday, March 29, 2007 11:41 AM To: [email protected] Subject: Re: Problems starting Slackware after new install >>> On Thu, Mar 29, 2007 at 9:32 AM, in message <[EMAIL PROTECTED]> , "Jones, Russell" <[EMAIL PROTECTED]> wrote: > That sounds like what my problem is. I did not install the "K" set. Are > there any other sets that must be installed? Usually, A, part of AP, and N are all that is required. (I moved s390-tools into A). I personally also install L and K. > *** > So, is it correct that when I IPL Slack/390 after the install, it will > not be accessible from the network, and will have to change the network > settings from the HMC? > *** Essentially, you're looking at two commands: ifconfig ifname ipaddress netmask route add default gw ipaddress Then, you can SSH in from the outside and edit /etc/rc.d/rc.inet1.conf appropriately. Mark Post ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
