... just using function 4 to read the config works in osa/sf. No need for functions 12/13. You learn something everyday if you want. David
-----Original Message----- From: Linux on 390 Port on behalf of Clark, Douglas Sent: Mon 6/18/2007 7:51 PM To: [email protected] Subject: Re: Verify network card speed I have not had a chance to check the HMC; but I didn't see anything using netstat -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Alan Altmark Sent: Monday, June 18, 2007 2:09 PM To: [email protected] Subject: Re: Verify network card speed On Monday, 06/18/2007 at 01:43 MST, "Clark, Douglas" <[EMAIL PROTECTED]> wrote: > I was asked if I "can you verify you are set t o100/Full on your side" > for my Linux LPAR; I have looked at the output from the hardware scan > and the sys log messages but I did not see anything that would show > that information / at least what I could understand from the data. > The output from "ifstatus eth0" is here: IIRC, this information is available in the OSA Advanced Functions of the HMC or via z/OS queries (NETSTAT DEV, I think). Alan Altmark z/VM Development IBM Endicott ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
