Just started installing and cloning SLES10 SP1 (Thanks for the (should be a) Redbook Mike !) and noticed that all the entries in zipl.conf and the fstab are all in the disk-by-id format. This is not very friendly to a cloning process ! Where can I set these values to use the /dev/dasd formats ? Thanks
Jerry Whitteridge Mainframe Engineering Safeway Inc 925 951 4184 [EMAIL PROTECTED] "Email Firewall" made the following annotations. ------------------------------------------------------------------------------ Warning: All e-mail sent to this address will be received by the corporate e-mail system, and is subject to archival and review by someone other than the recipient. This e-mail may contain proprietary information and is intended only for the use of the intended recipient(s). If the reader of this message is not the intended recipient(s), you are notified that you have received this message in error and that any review, dissemination, distribution or copying of this message is strictly prohibited. If you have received this message in error, please notify the sender immediately. ============================================================================== ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
<<penguin_html_6cc443b4.gif>>
