My experience with yast in sles10 is you need to partition the dasd
before creating the lvm group.
In the yast partitioning tool: Select Create.
Pick a volume you want in the lvm group.
Do not format, and select the "blank"
mount point.
Repeat the above for all dasd you want
in the lvm group.
Now create the lvm group.
Paul Noble wrote:
I am trying to create a logical volume, consisting of five 3390-3 (2.2G ea)
dasd volumes.
The volumes are attached to the vm as device addresses 202-206 in r/w mode.
Using Yast, all goes well, until I try to apply the changes. Then I get a
message saying:
Failure occurred during following action:
Creating volume group system
System error code was: -4010
I'm relatively new to Linux on VM and this is my first attempt to create a SLES
10 system. I do not know where to look up this error code.
Thanks,
Paul Noble, Systems Programmer
Cuyahoga County Information Service Center
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
--
Jim Fujimoto
County of Los Angeles
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
