The line about adding dasd is there so here is the output of the zipl
command:
zipl -V
Using config file '/etc/zipl.conf'
Target device information
Device..........................: 5e:00
Partition.......................: 5e:01
Device name.....................: dasda
Device driver name..............: dasd
DASD device number..............: 0200
Type............................: disk partition
Disk layout.....................: ECKD/compatible disk layout
Geometry - heads................: 15
Geometry - sectors..............: 12
Geometry - cylinders............: 3338
Geometry - start................: 24
File system block size..........: 4096
Physical block size.............: 4096
Device size in physical blocks..: 25596
Building bootmap in '/boot/'
Building menu 'rh-automatic-menu'
Adding #1: IPL section 'linux' (default)
kernel image......: /boot/vmlinuz-2.6.18-53.el5
kernel parmline...: 'root=/dev/VolGroup00/LogVol00'
initial ramdisk...: /boot/initrd-2.6.18-53.el5.img
component address:
kernel image....: 0x00010000-0x00388fff
parmline........: 0x00001000-0x00001fff
initial ramdisk.: 0x00800000-0x00b0bfff
internal loader.: 0x0000a000-0x0000afff
Preparing boot device: dasda (0200).
Preparing boot menu
Interactive prompt......: enabled
Menu timeout............: 15 seconds
Default configuration...: 'linux'
Syncing disks...
Done.
Bobby Bauer
Center for Information Technology
National Institutes of Health
Bethesda, MD 20892-5628
301-594-7474
It may help to run mkinitrd with -v to show verbose output. You should
see a line similar to:
adding dasd_mod with options dasd=200-201,210
If it does say this, can you paste the output of zipl -V?
--
Brad Hinson <[EMAIL PROTECTED]>
Sr. Support Engineer Lead, System z
Red Hat, Inc.
(919) 754-4198
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
