Sles9 sp4 guest under vm 5.3. We recently replaced our two 3592 drives with ts1120 drives. We also added two additional drives.
I created the appropriate file for /etc/sysconfig/hardware for the san attachment specifying wwpns for each drive. Upon reboot, the system does not see any of the new drives, but does still see the 3590s previously attached. Going into /sys/bus/ccw/drivers/zfcp/0.0.0402 (id of our fibre chanel attachment), I can go into the subdirectory created for each wwpn, and echo a 64-bit 0 (in hex) to unit_add, and the appropriate entries appear in /sys/bus/scsi/devices. Lsscsi also shows the new ts1120 drives. How to make these definitions permanent? I have tried doing a mkinitrd then zipl, but the 1120s disappear after the system is restarted. Thanks for any and all help. Gary Lee Senior System Programmer Ball State University phone: 765-285-1310 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
