Mark, I think so. Now when I go in to Yast, Network Devices, Network Card, it shows Traditional Method with ifup as the management selection.
If I look at the interfaces through there, they look correct. However, I can only seem to get one interface active at any given time. And it's not always, the same one. Usually, but... Dave Dave Stuart Prin. Info. Systems Support Analyst County of Ventura, CA 805-662-6731 [email protected] >>> "Mark Post" <[email protected]> 7/22/2009 9:57 AM >>> >>> On 7/22/2009 at 12:44 PM, David Stuart <[email protected]> wrote: > Hi Mark, > > Yes, I did. After the problem originally occurred. Both OSA interfaces > were 'dead'. Have you gone back into YaST to switch from Network Manager to "traditional" mode? Mark Post ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
