How? The signal command finishes in a sec. I have to wait for the message to arrive and trap it seperatly... how can I do that?
Offer -----Original Message----- From: Linux on 390 Port [mailto:[email protected]] On Behalf Of Michael MacIsaac Sent: Thursday, September 16, 2010 2:03 PM To: [email protected] Subject: Re: vmpoff and vmhalt Offer, You wrote: > Sadly that did not work... I'm just curious. Early in this thread it was recommended that you trap the message from SIGNAL SHUTDOWN. Usually about 15 seconds after signaling a Linux virtual machine to shut down, I get a message. For example: ==> q linux01 LINUX01 - DSC ==> signal shutdown linux01 ... then about 15 seconds later I see: HCPSIG2113I User LINUX01 has reported successful termination So why can't you trap the message: "HCPSIG2113I User LINUX01 has reported successful termination"? "Mike MacIsaac" <[email protected]> (845) 433-7061 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/ ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/
