You need to read the appropriate HMC Operations Guide for the processor you have. Each is different depending on the HMC level. The books have a section on remote HMC operation and how to set it up. It is not just the IP addressing, it is also permissions in the userid's on the HMC.
Doug Fuerst -----Original Message----- From: Linux on 390 Port [mailto:[email protected]] On Behalf Of Cameron Seay Sent: Monday, October 03, 2011 8:38 PM To: [email protected] Subject: Remote HMC access This is not a VM question per se, but maybe the group can help me. I am trying to access my HMC remotely. My school requires I use a VPN. The IP address, gateway and mask are set by my school, and are supposed to work with this VPN. I can ping the Gateway from home, but not the assigned IP (it is static and not DHCP). I used the CUSTOM NETWORK SETTINGS in the HMC, but I think I must have missed a setting. I have the IP set for eth0 and "routing enable". Does anyone know the generic settings for remote HMC access? Thanks. -- Cameron Seay, Ph.D. Electronics, Computer and Information Technology School of Technology NC A & T State University Greensboro, NC 336 334 7717 x2251 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/ ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/
