Are DTCVSW1 and 2 autologged and running disconnected? Marcy
-----Original Message----- From: Linux on 390 Port [mailto:[email protected]] On Behalf Of Melancon, Ruddy Sent: Monday, December 03, 2012 3:04 PM To: [email protected] Subject: [LINUX-390] VM6.2 Network issue I am trying to activate an LPAR with a new install of zVM 6.2. I have gone through the IP wizard and defined the network. When I try to IPL and access through a 3270 terminal on the network I cannot. When I display the OSA addresses it shows them all free. A query of the vswitch shows no devices on the group. I am trying to share an OSA with my production zVM 6.1 system. It is defined as a Layer 2. I defined 040 and 050 to the production system. I am trying to use 048 with the new system. Ay ideas? Ruddy Melancon Alabama Department of Transportation ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/ ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/
