When you run SERVICE, *only* the "test" build disks are modified, not the production disks. For Perfkit, this is the 6VMPTK20 200 disk. (PERFSVM 201 is the production disk.) So, just run SERVICE against the servlink file and then the updated module will be on 6VMPTK20 200. In PERFSVM, you can make a temporary change to the PROFILE EXEC to access the 200 disk instead of the 201 disk. When you restart it, it will be using the updated code instead of the production code.
Once you are able to run PUT2PROD, remove the PROFILE EXEC change also. On Thu, Jan 2, 2014 at 8:42 AM, Levy, Alan <[email protected]> wrote: > I am running 6.2 SSI w/4 members. I have a ptf to be applied for PTK. I > have already downloaded the PTF and detersed it into ses format. > > I cannot put this ptf into production at this time (has to be done on the > weekend and we're not available for the next few months). > > Is there any way to extract the ptk module from this detersed file. I can > just put that up temporarily. > > Thanks. > > ---------------------------------------------------------------------- > For LINUX-390 subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO LINUX-390 or > visit > http://www.marist.edu/htbin/wlvindex?LINUX-390 > ---------------------------------------------------------------------- > For more information on Linux on System z, visit > http://wiki.linuxvm.org/ > -- Bruce Hayden z/VM and Linux on System z ATS IBM, Endicott, NY ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/
