I'm working on a project that requires RHEL 7 running in an LPAR. I've never done Linux in an LPAR, always on top of z/VM, so its a new experience...ugh..
We've got it running finally and need to configure a 2nd network connection. The OSA that is available for use is on port 1 of the OSA card. Under z/VM, that would not be an issue as you add "p1" to the address when defining the vswitch, etc. However, I can't tell how to tell Linux that the device is on port 1. To make matters more complicated, the other port is already being used by this system for its main connection. So, basically, I need to use both port 0 and 1 on the OSA for different network connections. I've been looking at znetconf, but it doesn't seen to see any port distinctions and only sees the device addresses. Can someone point me in the right direction? Martha ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/
