On 12.05.2016 20:17, Michael MacIsaac wrote: > Hi, > > I've been trying 'preseeding' with no luck. To specify network values, you > cannot expect to get them on the network, right? So you can't add one line > to the parm file like "auto url=http://<installServer>/config/ubuntu01.cfg" > to point to a file on the network. > > Also I believe there's a limit of like 12 lines in the parm file, and there > would probably be a need for more than 12 settings. So, how to specify the > preseeding values? It is possible to set some preseeding values as kernel parameters in the parmfile and then point to a preseed URL, which means you could configure the network interface via parmfile and specify the remaining values in your remote preseed file. I have only done partial preseeding so far, though, so I don't know how far you can get. > > I know RHEL addresses this by having two CMS files, where the second one > can be longer. SLES just squeezes the variables into the 12 lines. > > Any help will be appreciated, thanks. > > -Mike M >
-- Mit freundlichen Grüßen/Kind Regards Viktor Mihajlovski IBM Deutschland Research & Development GmbH Vorsitzender des Aufsichtsrats: Martina Köderitz Geschäftsführung: Dirk Wittkopp Sitz der Gesellschaft: Böblingen Registergericht: Amtsgericht Stuttgart, HRB 243294 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/
