>>> On 5/19/2016 at 04:41 PM, Alan Altmark <[email protected]> wrote:
> I did. Unfortunately, being ignorant of script writing on Linux, I don't > know any more than I did before I read it. :-) Ah, well... In that case, I check to see if there's 1 or 3 numbers separated by periods specified for the device. So, 0123 versus 0.0.0123. If one number, then I pre-pend 0.0. to it, otherwise I leave it alone, other than to make sure the first two "levels" are a single digit each. Then I look in /sys/bus/ccw/devices/ to see if that busid exists. If not, bail out. There are other sanity checks, but in essence, I already did what you suggested when I first wrote the script. I just didn't allow 0.0123 as a valid input. Mark Post ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/
